Mike Vapes

DotMod DotRda single coil 22mm RDA – Build & Wicking Tutorial – Mike Vapes

Facebook Comments
Tags

Related Articles

25 Comments

  1. This ain't for me…I already got these bad @$$ single coil flavor bangers known as the Recurve n Drop Solo…u might know something about that ?!!! Haha…seriously tho, good review Mike!

  2. Was totally looking at this to go with the Petri 22mm mech I’m gonna order, but I’m gonna pass. I’ll stick with my Recurve RDA, and I’m gonna order a few of the 22mm conversion caps for it and be matchy matchy! The Recurve flavor is ON POINT!

  3. Not to be a dick but the prebuilt Wotofo coil you showed is actually the backwards one. It’s wound counter clockwise instead of clockwise. Most builder made and pre-made coils come wound clockwise and do match up with this. Just don’t wanna scare people off from buying from builders.

  4. As a builder , i dont mind the design of this at all. Its funny to watch some reviewers throwing a fit cause they cant put a damn coil in the thing lmao. It is also a nice looking rda. I need this and a citadel in my life immediately .

  5. DotMod definitely has their own way of doing things. I think that it is silly that they did not make this a four screw deck rather than just two. The deck looks too shallow and like all of their rda’s the airflow holes are too low inviting leakage. They really need to rethink their designs. I’ll be damned if I’m going to spend that kind of money on a flawed design. (Tell me your fancy single post Dot 24 rda doesn’t leak like a bucket with a hole in it!) Mine went into the unusable pile w/i 24hrs after I tried 3 builds and they all leaked.It literally pisses ejuice!

  6. I got one of these to go with my new 100W 21700 regulated DotSquonk. Using the jig, I wrapped a 0.14 ohm alien and installed it in about 5 minutes. My only gripes are that it requires an extremely delicate touch to squonk w/o getting serious spit back (never leaked) and (God only knows why DotMod always does this) the tiny drip tip requires that you French Kiss (IE: slip it the tongue) to vape it! I think somebody in the DotMod design department has lips shaped like an asshole!

  7. Thank you for your great reviews. Love them. you are helping me decide on the whole DotMod Squonk 100w + RDA. Anyhoo, here is my 2c on coil install: another YouTuber has reviewed this RDA and there's a logic to the coil "install". Placing it down the right way, at teh right angle, makes it a breeze to install. You just need to use the jig, lower it in at the right angle, just twist it in the holes and rest the tool into the slots; screw the screws and you are done. It really makes a lot of sense! I don't know if I'm allowed to link here, so you have to diy or die….

  8. The fact that this is marketed as a squonking rda, I find it interesting that you failed to mention the fact that the air holes are at the same level of the coil and squonk pin and it is incredibly easy to squonk juice straight out of the rda making a mess. Dotmod didn't even cut any channels into the deck to allow the juice to travel directly from the opening of the squonk pin to the 2 juice wells. Major fail in my opinion.

  9. Well, I’ve got to eat my words.. I found one of these on sale and bought it. It’s a minor challenge to build but I’ve got to admit as long as you are cautious when squonking, its a real flavor banger. I put it on my. DotSquonk and it’s performing great!

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close