Aryt I'm new to this shit, and I just bought this exact model, when filling the top for the first time, do I just fill the side holes or put some directly into the middle hole where he coil is visible ???
How long does this take to charge? I'm a little upset that this mod doesn't have 2A charging, pretty much all Smok products do so there's no reason this one shouldn't.
My TC 80w OSUB also leaks. After careful study, I discovered the cause to be both subtle and negligible. The cause is in the drip guard. With juice still pooled at the bottom of the tank, you may notice a few air bubbles are produced as you unscrew the drip guard. The guard has an o-ring which seals against the top ring; and that seal creates negative or positive pressure within the tank as you remove/replace it, respectively. Removing (unscrewing) the drip guard produces negative pressure/suction on the tank, drawing air bubbles up through the coil. Replacing the guard results in just enough positive pressure to force a few drops of juice down through the coil–those drops eventually leak out through the air vents.
I've been able to minimize the leakage. When replacing the guard, hold the tank upright only long enough to so that the guard's outer o-ring comes into contact with the rim as you thread it in. Then hold the tank sideways as you finish screwing the guard down. Some juice will still be forced through, but the reduction is significant enough to no longer stress about it leaving stains in my shirt pockets.
Hey how do you know when a coil is burnt up or when to change the filter? I honestly have been vaping around 25-30 W only for about a week since I bought this guy.
The tight seal on the cap can cause changes in pressure when removed and replaced which can cause leaking, so close the air intake before refilling. I also have leaking issues with my baby beast when using thinner juices, so another way to prevent leaking try thicker juices such as 100%vg and not thinned with alcohol or water.
There has to be a way to replace the battery , i have the 40w kit by smok. there are # T6 torxs screws at the bottom .too much fine materials an craftsmanship into this mod ,to just throw away when the battery goes out.
VaporDNA has the kit for $49.99
Aryt I'm new to this shit, and I just bought this exact model, when filling the top for the first time, do I just fill the side holes or put some directly into the middle hole where he coil is visible ???
How long does this take to charge? I'm a little upset that this mod doesn't have 2A charging, pretty much all Smok products do so there's no reason this one shouldn't.
My TC 80w OSUB also leaks. After careful study, I discovered the cause to be both subtle and negligible. The cause is in the drip guard. With juice still pooled at the bottom of the tank, you may notice a few air bubbles are produced as you unscrew the drip guard. The guard has an o-ring which seals against the top ring; and that seal creates negative or positive pressure within the tank as you remove/replace it, respectively. Removing (unscrewing) the drip guard produces negative pressure/suction on the tank, drawing air bubbles up through the coil. Replacing the guard results in just enough positive pressure to force a few drops of juice down through the coil–those drops eventually leak out through the air vents.
I've been able to minimize the leakage. When replacing the guard, hold the tank upright only long enough to so that the guard's outer o-ring comes into contact with the rim as you thread it in. Then hold the tank sideways as you finish screwing the guard down. Some juice will still be forced through, but the reduction is significant enough to no longer stress about it leaving stains in my shirt pockets.
Does the baby beast have TCcoils? I have the alien with the Helmet tank and my complaint, no TC coils available for a good temperature control mod.
Correction confused alien with the Koopor mini 2 Knight Kit by Smok, which.has the Helmet tank.Don't like the hemet tank because no TC.
hate the tank but use my baby beast and big baby beast on this mod.
bought this today in the UK for £44.00 Chucking the vapour
Can this tank become RBA?
how do I upgrade it?
You know you can lock ? it if you press the two buttons at the same time too and is faster then clicking 5 times
Do I have to turn on the screen to start vaping it?
I think about getting one cause I am pushing a few years on cigarette need so I won't get cancer still of vape to
I just got this and when I go to take a hit. It like spits juice back in my mouth. What should I do???
The mod charges very fast in about 40 minutes is that normal guys
And it out of charge after about 200 puff ?
It holds 2ml of liquid
Mines wont charge for some reason
i have a small issue with this mod,,, when i pull i hear the ejuice is boiling and i get some of it on my tongue !
anybody know about it?
Hey how do you know when a coil is burnt up or when to change the filter? I honestly have been vaping around 25-30 W only for about a week since I bought this guy.
The tight seal on the cap can cause changes in pressure when removed and replaced which can cause leaking, so close the air intake before refilling. I also have leaking issues with my baby beast when using thinner juices, so another way to prevent leaking try thicker juices such as 100%vg and not thinned with alcohol or water.
I got mine for $55 at a casino. I like it so far, but I also get some leaking. I didn't check the tightness of the coil before filling though.
There has to be a way to replace the battery , i have the 40w kit by smok. there are # T6 torxs screws at the bottom .too much fine materials an craftsmanship into this mod ,to just throw away when the battery goes out.
My coil will not cum off how do I change my coil
How do u lock the watts?
Love this one. Tried a few different types and so far this one is the best. I have it red with black trim