Mike Vapes

Mage GTA By Coilart – Wicking Tutorial – Mike Vapes

Facebook Comments
Tags

Related Articles

25 Comments

  1. Mike Vapes,
    You Sir are a life saver! Found this video in hopes for a new wicking technique for the Mage GTA. I have tried about 6 different builds and tries wicking each on about a dozen different ways, I was never able to get a nice saturated and flavorful vape until 5 minutes after I watched your video! I just subbed, have a lot of videos to catch up on lol. Solid review, straight to the point and an amazing job! Now vaping this GTA and finally getting the full saturated flavor potential of this tank! Thank you again!

  2. I loved the first mage tank that came out,which to me had the best flaver ever , but that screwed up chimney set up with bad threads where you had to line the slots it pissed me off time after time until I ultimately smashed it, to solve the problem of the juice getting to the bottom they should have made the walls of the chimney a little thicker and Machined about four virtical 4mm slots from top to bottom, problem solved !

  3. I just ordered one of these haven't received it yet. I had the first mage rta which in my opinion was the best Flavor tank I have ever used .but the way you had to line the slots to screw the chimney in which always cross threaded , it was just to much of a pain in the ass for me So I never used it again Thanks for the Info Mike.

  4. Hey Mike do you think that you can use the vape band over top glass and top section to hold the glass from leaking or comming off if you have to mess with your build ?

  5. Damn Mike how did I miss this one.   I know work has me left with very little time but never in a million years would I think I would miss one of your videos.   Hmmm I better get off my ass and see what else I missed……..

  6. For the issue of the juice not flowing down in between the chimney and the glass I took a 1/16 cutting disc ground six virtical slots down the chimney, problem solved.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close