Zophie Vapes

Triton Sub-Ohm Atomizer Tank by Aspire & RTA System (RBA base) Review

Facebook Comments
Tags

Related Articles

25 Comments

  1. @zophie Vapes are you saying that just the Aspire .4 and 1.8 should not be used with temp control Mods? I am using the triton tank and use the Atlantis .5 ohm coils with my X cube II on watt mode not temp mode?

  2. I've been using this tank for a while now and… is't "meh". I really don't like that glass tube can't be disassembled, even though I've never run into cleaning problems. I'm using the rba kit (wich had to be bougth separately, another con) and it's ok… not fantastic, but ok: I'm gonna try to make a verticoil inside there, sooner or later. Tossed away the 1.8 coil: it was just unusable for me – and the other pre-installed coil lasted very short. Top-filling operation is a snap.

  3. a review after one day of use? that's first impressions, not a review. i really dont like when everyone tries to review it as quickly as possible. what if it breaks after a week of use but you only used it for a day?

  4. For anyone interested or curious, if you make a coil with a 2mm ID using 26 gauge kanthal you will get a decent resistance and the airflow will be better, basically on par with their vertical coils. The smaller diameter coil (and smaller amount of cotton) just block off less air.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close