Mike Vapes

Wismec Reuleaux RX Mini Kit Plus Surprise – Mike Vapes

Facebook Comments
Tags

Related Articles

25 Comments

  1. Does anyone know about the wattage mode starting low and and then going into normal temp? It's like there's a cut off on 28 watts then goes up to normal. Don't know how it happened or how to fix it lol

  2. Is it a good one for durable when use for long time i need device that's not complexible self charge easy to use i compare between smoant battlestar 200w which one d u recommend me i need especially durable device thx

  3. So I purchased a Wismec RX75 at a local shop.
    2 weeks after purchase the digital display started flashing, nothing would respond.
    I swapped out the battery with a new one, cleaned the connectors, tried updating the firmware, nothing worked.
    The local store I purchased it out told me to contact Wismec. I contacted Wismec through their support multiple times.
    After weeks of nothing, I was told to email them a video of the product showing its defects and the security seal which I did.
    I was told they were not responsible.
    I would NOT recommend this product and am truly disappointed in Wismec for not even having the decency to take responsibility for their faulty product.

  4. I have two questions. Does this mod scratch easily like the IPV D3 which basically gets all roughed up within a week and is the top part easily scratched when you screw a tank on it

  5. I'm new to vaping with tc mods, i got the mini, and right away half of the clear rubber ring was stuck to the tank's glass rim, the other half to the bottom of the lid after unscrewing it and removing the lid. Even after putting it back, the thing leaks from there a lot. Every time i go to hit it above 25w it gags n chokes me, and no smoke, it wont hit at all under 25w. Also sounds like a water bong when drawing from it. pops juice in my mouth, too. I put a drop or 2 of ejuice in that little hole like you did to prime it. thinking I flooded it i took it apart and cleaned it, now it leaks somewhere else… this is the tank from the starter kit, as well. what i do wrong? there no instructions about loading an priming either..

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close