Mike Vapes

Combo RDTA By iJoY – Mike Vapes

Facebook Comments
Tags

Related Articles

25 Comments

  1. Mike bought this today and its leaking from the bottom o-rings. Do you guys have any solution for this problem. Mike i trust you watched your video an decided to buy this overall its a good device but leaking from o-rings is a very big con for me.

  2. finally got the bitch, always wanted to, that clamp style deck man oh my, the best of the limitless series in my opinion her and the rdta 5 which i did not get till now, thank for the review again

  3. Tired of buying coils (ordering), thinking of buying this even though the V2 is out. this ones much cheaper on FT. would a 24 g or 26g dual contact build be good enough for this thing?

  4. Gotta love when a new tank comes with some awesome coils! That is an great selling point. Although I have always wondered why people don't want their cotton to come down into the tank itself..besides aesthetic reasons, why not? At least I would be able to use most of my juice before having to fill up again, unless I tilt the box every time I vape. If you don't tilt this vape and you don't extend your cotton down into the tank at least a little bit, you basically just have a 2-3ml tank, because your filling it every time it gets below where the cotton reaches. As always thank you for the review, i will be picking this up, hopefully my wholesale vendor gets this in stock xD
    REPLY

  5. Hey mike,i want a sub ohm with 0.05ohm coils does these exists or do i have to build a rda/rdta tank and what is the lowest ohm (resistance u can build,now i am sub ohming with a aspire cleito 120 and 0.16 ohm.thx

  6. I appreciate the time you take too keep the vape community informed,,it gives people such as me the opportunity too make what is best feal to a good buy which is a plus time saved and most important ?

  7. Mike, you're awesome man! Your review was my decision to get away from Smok. I love the Ijoy Combo! Thank you for the detailed review! I am ecstatic with mine!

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close