Mike Vapes

Joyetech Cuboid 200w TC & Cubis Tank – Mike Vapes

Facebook Comments
Tags

Related Articles

25 Comments

  1. that tanks comes with the battery mod. Obviously it's the original tank for the mod. So there for they have a tank for it and you don't know this how, but you know everything else?

  2. I have ran all three coils at 200 watts with no problem. Wattage isn't the answer to vaping. It's the input and output that matters, wattage not so much.

  3. Hey mike! I was thinking about getting this mod, does the Gemini RTA sit flush on this? Since I'm currently using the eVic VTC and I have to use a spacer to get it to screw down properly. Thanks

  4. The Cubis tank was a big disappointment! It works well when it works however there is a design fault in this product which makes warm liquid shoot out of the tank all the time. As soon as you change the coil it will work perfect for a day but after that the coil soaks up to much liquid.
    every time before use I have to open up and dry the coil for liquid and as a result of this there is lots of liquid that gets wasted. This is with an SS 316 0.5 ohm coil.
    There is also heaps of bad reviews about this tank if you spend 2 minutes searching for it.

  5. To fix the spitback on Cubis 0.5 coil, try this–>

    •unscrew the top part which the drip tip is connected too, then blow hard a couple times through the drip tip. Screw it back in.

    -Do this every 10 draws you take.

    Filling up the tank will usually cause an initial problem every time but that's the one drawback.

    Just do what I said above every 10 draws and you won't have a problem.

    30 – 32 watts
    Istick Pico
    Innokin Cool Fire 4 Plus

  6. Sorry Mike but with my Cuboid the battery on the right always drops charge quicker than the left even if I swap them round, other than that good review buddy.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close
Close